Your are here: Strider Link Series
Select your language:
Strider Transmitter Link features - full version (all cards installed)
| Type: | Solid State |
| Direct FM | |
| Frequency Synthesized |
|
| Crystal Referenced | |
| RF power output | 8W tipically, 10W max, adjustable |
| RF output connector | Type N or UHF under request Type N or UHF under |
| Deviation: (100% modulation) | +/- 75kHz |
| +/- 50kHz (composite) | |
| +/- 40kHz (monaural) | |
| +/- 25kHz (RPU - Brasil only) | |
| Frequency Stability | +/- 5ppm or better (1 or 2 ppm under request) |
| Harmonic emission | More than 60dB below carrier level |
| Modulation capability | Mono operation and Composite main subcarrier |
| Power Source | 85 to 265VAC 47-63Hz switched power supply system, universal full-range. 48W |
| 12V-DC input socket for mobile operation (battery source: minimum 10,8V maximum 14V) |
|
| Dimensions | 1 rack unit (44,45mm) high 19” (483mm) wide 5” (125mm) deep |
| Shipping Weight: 3,5kg | |
| Modulation inputs: | Composite: 0dBm nominal for +/- 75kHz
deviation @ 1kHz adjustable - MPX input BNC connector 10kOhms unbalanced. |
| Frequency range: 30Hz to 200kHz 1 BNC connector |
|
| Monaural: 0dBm nominal for +/- 75kHz
deviation @ 1kHz (internal jumpers for -10dBm or +6dmB) |
|
| XLR connector - balanced electronic
floating - 600 Ohm - Frequency range: 30Hz to 20kHz |
|
| Mono input is made by the LEFT XLR
connector (internal jumper to 50us or 75us pre-emphasis) |
|
| SCA input: 0dBm nominal for +/- 75kHz
deviation at 57kHz adjustable. Impedance 10kOhm. BNC Frequency Range: 50kHz to 200kHz |
|
| Audio Processor Dual-Band card: |
Stereo active bass boost circuit 3dB @ 80Hz |
| Stereo crossover 6dB in-phase correction: *Low pass: 30Hz to 200Hz - 1st way *High pass: 200Hz to 15kHz - 2nd way |
|
| Stereo compressor and limiter section
of the card: *1st way: attack time 10ms, release time 1s *2nd way: attack time 4ms, release time 500ms |
|
| Maximum compression: 20:1dB | |
| Stereo Generator Card: |
Jumper selection for pre-emphasis: 50us or 75us |
| Frequency Response: 20Hz to 15kHz
(THD+N<0,1%) (When installed the digital 15kHz low pass filter) |
|
| Stereo Separation: Better than 60dB @ 1kHz | |
| Pilot tone frequency 19kHz +/- 1Hz (1Vpp output at the BCN) |
Strider Receiver Link - features
| RF input connector | 50 Ohms type N Female, UHF female on request |
| Sensitivity | Composite: 100uV or less required
for 65dB SNR, left or right channel de-emphasized, demodulated. |
| Monaural | 20uV or less required for 65dB SNR |
| Composite selectivity | 3dB IF bandwidth: +/- 125kHz |
| 80dB IF bandwidth: +/- 1,2MHz | |
| Monaural selectivity | 3dB IF bandwidth: +/- 90kHz |
| More than 60dB below carrier level | |
| Modulation capability | 80dB IF bandwidth: +/- 1,2MHz |
| Modulation output | Composite: 4Vpp @ 600 Ohms, adjustable
unbalanced Frequency range: 30Hz to 80kHz (1 BNC connector) |
| Monaural output | 0dBm @ 600 Ohms, balanced Frequency range: 30Hz to 15kHz (1 XLR connector) |
| Stereo decoder outputs Stereo | 0dBm @ 600 Ohms, balanced Frequency range (Left or Right): 30Hz to 15kHz (2 XLR connector, 1 Left Signal out, 1 Right Signal out) Stereo Demodulated separation: 40dB or better |
| Power Source | 100/120/200/240VAC 50 or 60Hz 15W max. |
| Dimensions | 1 rack unit (44,45mm) 483mm wide 125mm deep |
| Shipping Weight | 3,5kg domestic |
){kind=link}